MOTOR MOUNT PLATES

We have a few different light weight motor plates. We have a one piece motor mount plates that are designed to position motor in the original position. The motor mount plate is available for a 3 cylinder motor in a DSA and S2000 chassis. We have a one piece motor plate for the 809 in the CKIII chassis as well that you might need to trim around the tie rod. Or if you perfer me make a 2 piece strap style motor plate for the 3 cylinders in the CKIII chassis. We have 2 different kits available for the RT chassis. One is to mount a 3 cylinder motor in the RT chassis recommended for racing only. This kit consist of a motor plate, steering post, and the necessary brackets for the installation. To install the motor in the RT chassis you will need to cut 1/2 the oil pump housing off or put a small square hole in the motorplate to accommodate the housing, but this tends to make the motorplate weak causing it to possibly crack. The other kit we have is one that will allow you to convert your Mach Z 1000 motor to a carburated motor. This kit will include the motor mounts, manifold plates, boots, rave blocks and the necessary machining to the case and rave valves. The customer will need to send in base and rave valves to have them machined for this application. And when you convert over to carbs this kit will rotate the motor, so your exhaust pipes are no longer going to fit and you will need to purchase a new set.